You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Yes. The "digits after decimal" setting (actually there are two settings, one for millimeters and one for inches) only affects linear dimensions. It does not seem useful to have more than two digits printed for angles anyhow.
Fair enough - I'm helping to design a precision (vernier) protractor to measure 1/60 degree of arc, and >2 digits would be helpful but is far from necessary.
Setting the precision to > 2 digits doesn't affect angle dimensions/constraints - is this deliberate?
The text was updated successfully, but these errors were encountered: