Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Our recommended way to write testbenches is racy #377

Open
whitequark opened this issue May 3, 2020 · 4 comments
Open

Our recommended way to write testbenches is racy #377

whitequark opened this issue May 3, 2020 · 4 comments

Comments

@whitequark
Copy link
Member

whitequark commented May 3, 2020

We currently nudge people towards writing testbenches where the testbench modifies signals (inputs, registers) on the same edge as the edge-triggered synchronous logic (i.e. posedge for default posedge domains), but this is wrong:

  1. testbenches written like this are susceptible to races, especially if yield Settle() is used;
  2. VCD files produced by testbenches written like this are hard to read because changes to inputs (and, rarely, registers) made by the bench, as well as any combinatorial logic triggered by those changes, appear at the same instant of time in the waveform viewer as the changes caused by the posedge.

Migen did not suffer from the problem (1) because it had a far simpler simulator that always ordered synchronous logic after the testbench logic and had no way to advance the simulation by zero time. (However, this caused severe issues for testbench logic by making it impossible to observe combinatorial feedback; e.g. it is not possible to implement a 1-cycle FIFOInterface.read() in Migen).

Migen did suffer from the problem (2).

@whitequark
Copy link
Member Author

See also #228.

@whitequark
Copy link
Member Author

What I think we should do is to recommend using the inactive edge of a clock domain for testbench logic. This is actually already the recommended way to use CXXRTL, for the same reason. This implies eliminating or reworking Tick as it currently exists.

@whitequark
Copy link
Member Author

There is a partial solution to issue (1) in a branch. We discussed issue (2) on IRC and it is possible that nothing needs to be done there because if the DUT was embedded in a normal module, the waveform dump would have the same problem as with the recommended way of writing testbenches.

@github-4o
Copy link

github-4o commented Mar 10, 2021

my group has been using this approach for years cause we run our testbenches for both rtl and post-synthesis netlists. so the first things i did with nmigen is:

  1. add inactive edge action for sim
  2. add compatibility layer for nmigen sim and cocotb

the letter ensures we'll run the same testbenches for nmigen code, generated rtl and partial vendor-specific netlists. not quite there yet, but we are working towards it.

that was my 5 cents invested into motivation for inactive edge action. as for the actual fix, i'm using the attached patch
patch_nmigen_sim.txt

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Development

No branches or pull requests

2 participants